Current Position:首页 > Products > Pre-processing

Flaking

TIME:2014-10-21 11:12:25FROM: AUTHOR:
Flaking known as "tablet", "flaking." It is the use of mechanical action, the process oil from a sheet pressed into the particulate. The purpose of flaking, and...

Flaking known as "tablet", "flaking." It is the use of mechanical action, the process oil from a sheet pressed into the particulate. The purpose of flaking, and that tissue damage fuel for steaming and roasting to create favorable conditions for the press or the leaching time, so that the grease can be successfully separated.
The basic requirements for rolling embryo embryo is expected to be thin, uniform surface, less powder, do not reveal oil, pinching weak, let go spread the powder is controlled at 1 mm mesh sieve material does not exceed 10% to 15% .

                       液压轧胚机.jpg
After completion of the rolling material embryos Embryo heated to control the flooding point at about 7%, the powder is controlled at 10% or less. When the corn germ increased thickness of 0.4 mm or more, even if the amount of solvent is increased, it is difficult to achieve a low residual oil rate. Therefore, we must use hydraulic pressure flaking machine, so that the embryo slice thickness control at 0.25 to 0.30 mm, and the embryo piece solid. This will not only not increase the degree of embryo powder tablets, but also conducive to the leaching solvent. Common equipment: one-on-roll-embryo, embryo on roll.